G06.27 Software Installation and Upgrade Guide

Overview of Installing G06.27
G06.27 Software Installation and Upgrade Guide—540067-001
1-39
SCF Storage Subsystem (Online Disk Remirroring)
(G06.21)
See Support Notes S97057 (T9101D41 Spooler Collector Data Files Have Changed
Format) and S99086 (NSK Spooler—Migration and Draining Instructions) for more
information on proper shutdown of the spooler.
CSPOOL Set at HIGHPIN
Beginning with G06.19, a new spooler SPR T9101D48^AEY is introduced. This PVU is
installed by DSM/SCM with CSPOOL at HIGHPIN. If you do not want this setting, you
can change CSPOOL to use LOWPIN by issuing the BINDER command:
CHANGE HIGHPIN OFF IN CSPOOL
SCF Storage Subsystem (Online Disk Remirroring) (G06.21)
OSM automatically recognizes online remirrored disks. However, you cannot perform
online reconfiguration of a mirror drive while TSM ($ZTSM) is running. You must
always stop the TSM server process before you implement online disk remirroring
(ODR). After issuing SCF commands for ODR, restart the TSM server.
During the ODR operation when using TSM, error 00012 might appear. For cause and
recovery information, see Appendix B in the SCF Reference Manual for the Storage
Subsystem.
Detailed syntax for using SCF commands to configure ODR are documented in the
SCF Reference Manual for the Storage Subsystem.
SWID (T9298G02) (G06.27)
SWID is the software identification utility invoked by the SYSGENR program that audits
file identification information about your software. You must restore and receive the
new SWID PVU before you install the G06.27 SUT. See Copy (RESTORE) the
T6031G02 DSM/SCM Product Version and SWID to Disk on page B-5.
Tandem Failure Data System (TFDS)
Ensure that TFDS is configured properly on the system. (TFDS monitors processors in
NonStop servers for software failure notifications.) The dump volume should not be
protected by Safeguard, and should also be properly configured.
Note. DSM/SCM automatically sets CSPOOL to HIGHPIN and automatically overlays the
current object file CSPOOL with the original from the SUT whenever a subsequent Build/Apply
is performed. See S03006A.