G06.27 Software Installation and Upgrade Guide

Overview of Installing G06.27

G06.27 Software Installation and Upgrade Guide—540067-001

1-45

Visual Inspect (G06.20)

G06.20 includes the Inspect subsystem (T9226G06) and the Visual Inspect server

(T9756AAH) that support PIC programs and DLLs. This version of the server requires

version 2.4 of the Visual Inspect client (T7877AAD).

If you run client product version 2.3 with a G06.20 or later RVU, the client is connected

automatically to the previous version of the server (T9756AAG), and you will not be

able to debug or analyze snapshot dumps from a PIC process.

Unfortunately, client product version 2.4 is incompatible with earlier versions of the

server. Therefore, it can be difficult to debug from the same workstation on multiple

systems, where some systems run G06.20 or later RVUs and some run earlier RVUs.

There are two ways to approach this problem:

•

Install the latest server on the earlier NonStop systems, along with a compatible

version of the Inspect subsystem. You can install Visual Inspect server SPR

T9756AAH and Inspect subsystem SPR T9226AAK on an HP NonStop K-series

server running the D45.00 or later RVU, or on a NonStop S-series server running

G05.00 through G06.19 RVUs. See the T9756AAH softdoc.

•

Install both Visual Inspect client product versions 2.3 and 2.4 on the workstation.

However, you cannot run both at the same time, and version 2.3 can encounter

problems after 2.4 has run.

WAN Wizard Pro (G06.21 through G06.27)

The NonStop System Console Installer CD (S7X-SWV1/HNSC-SWV1, Update 6 and

Update 7) includes the WAN Wizard Pro client version 5.00. This client version is

compatible with G06.21 and later SUTs only. If you have to fall back to a pre-G06.21

RVU, you must de-install the previous WAN Wizard Pro and re-install the previous

WAN Wizard Pro on your system console. See the WAN Wizard Pro S04064 for

details.

X25AM

A new SCF line modifier, EMSFORFRMR, is provided so that an EMS message is

displayed when a link reset occurs from a Frame Reject (FRMR) condition on an

X25AM line. The modifier accepts values in the range from 0 to 200. Configure this

SCF modifier with a nonzero value to enable the generation of an EMS message

during an FRMR condition. (By default, the feature is disabled.)

See the X25AM Configuration and Management Manual and the X25AM Management

Programming Manual for more information.

Note. Note that the Visual Inspect client is an independent product and must be ordered

separately. HP strongly recommends that you upgrade both the client and server products

at the same time.

See all related softdocs for installation and configuration information.