G06.28 Software Installation and Upgrade Guide

Contents
G06.28 Software Installation and Upgrade Guide—541688-001
viii
16. Running ZPHIRNM to Reactivate the Previous
Software Revision
Returning Processor Boot Code to the Previous Version (Using TSM) (continued)
Return the Processor Boot Code to the Previous Version 15-2
Returning SP Firmware to the Previous Version (Using TSM) 15-2
Determine the Correct Version of the Previous SP Firmware 15-2
Download the Previous SP Firmware File to the System Console 15-3
Return the SP Firmware to the Previous Version 15-3
Returning SCSI Boot Code to the Previous Version (Using TSM) 15-3
Determine the Correct Version of the Previous SCSI Boot Code 15-3
Return the SCSI Boot Code to the Previous Version (Using TSM) 15-4
Returning SP Firmware to the Previous Version (Using OSM) 15-5
Returning Boot Code Firmware to the Previous Version (Using OSM) 15-6
16. Running ZPHIRNM to Reactivate the Previous Software
Revision
Alerts 16-1
Drain the Spooler 16-1
Run ZPHIRNM 16-2
Using PREVIEW Mode 16-2
Run ZPHIRNM 16-2
Verify That ZPHIRNM Ran Successfully 16-3
17. Loading the Previous RVU and Resuming Normal
Operations
Alerts 17-1
Prepare to Stop the System 17-2
Halt the Processors 17-2
Remove Hardware Installed During Migration
17-2
Perform a System Load With the Previous SYSnn and CONFxxyy
17-3
Reload the Remaining Processors 17-3
Resume Normal Operations 17-4
Configure Spooler 17-5
Re-configure DSM/SCM User IDs (If Necessary) 17-5
A. Using DSM/SCM to Install SPRs
Tools for Managing SPRs A-1
Scout for NonStop Servers A-1
DSM/SCM A-2
SPRNOTES A-2
Install SPRs With DSM/SCM A-2
Save the Current Configuration A-2