G06.28 Software Installation and Upgrade Guide

Preparing to Upgrade the Server Software
G06.28 Software Installation and Upgrade Guide—541688-001
4-15
Check the Status of the Spooler Collector
4. From NSKCOM, perform a STATUS to verify which swap files are in use. For
example:
4> nskcom status swapfile *
NSKCOM - T5838G05 BASE (04AUG98) - Jul 27 1998
Copyright (c) 1995, 1997 Tandem Computers Incorporated
$SYSTEM.SYSTEM.ZSYSCFG
KMS.SWAPFILE = 0 $AUDIT0.ZSYSSWAP.CPU0
KMS.SWAPFILE = 1 $AUDIT0.ZSYSSWAP.CPU1
KMS.SWAPFILE = 2 $AUDIT0.ZSYSSWAP.CPU2
KMS.SWAPFILE = 3 $AUDIT0.ZSYSSWAP.CPU3A
.
.
.
Status of $AUDIT0.ZSYSSWAP.CPU0
CPU 0
CPU Pages: Total 32768 Reserved 9038 Available 23730
Peak CPU Pages ever reserved 12869
Threshold 27852 CPU pages
Status of $AUDIT0.ZSYSSWAP.CPU1
CPU 1
CPU Pages: Total 32768 Reserved 5275 Available 27493
Peak CPU Pages ever reserved 10978
Threshold 27852 CPU pages
Status of $AUDIT0.ZSYSSWAP.CPU2
CPU 2
CPU Pages: Total 32768 Reserved 8541 Available 24227
Peak CPU Pages ever reserved 13228
Threshold 27852 CPU pages
Status of $AUDIT0.ZSYSSWAP.CPU3A
CPU 3
CPU Pages: Total 2048 Reserved 1541 Available 507
Peak CPU Pages ever reserved 1638
Threshold 1740 CPU pages
.
.
Check the Status of the Spooler Collector
Check that the spooler collector is active and not 100 percent full.
At a TACL prompt, start SPOOLCOM and issue a COLLECT, STATUS command. For
example:
1> spoolcom $spls; collect, status
COLLECT STATE FLAGS CPU PRI UNIT DATA FILE %FULL
$S ACTIVE 3 , 1 154 4 $OPS0.SPL.DATA 44