G06.28 Software Installation and Upgrade Guide

Updating Processor Boot Code
G06.28 Software Installation and Upgrade Guide—541688-001
8-17
Reset the Processors To Complete Updating the
Processor Boot Code (Both for OSM and TSM)
Reset the Processors To Complete Updating the Processor Boot
Code (Both for OSM and TSM)
You must perform a Reset action or equivalent (Start System in the OSM or TSM Low-
Level Link) of the processors after you have updated the processor boot code and if
you did not select the explicit online boot code option in either TSM or OSM. Use the
Reset action from either the OSM or TSM Low-Level Link. The Reset operation
terminates all processes running on a processor, stops the processor, and places the
processor in a known state, ready for a Prime for Reload or Load action.
1. Log on to the server using the OSM Low-Level Link or TSM Low-Level Link
Application.
2. On the toolbar, click Processor Status.
The Processor Status dialog box appears.
3. Select the processors that you want to halt.
4. From the Processor Actions list, select Halt.
5. Click Perform action.
6. Monitor status of the halt action. After the halt action has successfully finished, a
completed message appears.
7. From the Processor Actions list, select Reset and click Perform Action.
8. See System Load Using the TSM or OSM Low-Level Link on page 11-4 and
Reload the Remaining Processors (If Necessary) on page 11-6.
Note. You can also perform an equivalent action using the TSM or OSM Low-Level Link on all
processors when you perform a Start System. See System Load Using the TSM or OSM Low-
Level Link on page 11-4 and, for more information on Reset, see The Reset Operation on
page 11-8.