G06.28 Software Installation and Upgrade Guide

Overview of Installing G06.28
G06.28 Software Installation and Upgrade Guide—541688-001
1-7
SWID
DSM/SCM. The DSM/SCM client and server product version enables you to manage
OSS files and is compatible with systems running H-series RVUs.
•
If you are upgrading to the G06.28 RVU, download the most current client version
of DSM/SCM (T6031G02) from the ZDSMSCM subvolume after the G02 new
product version has been restored and activated from the SUT tape. The
DSM/SCM T6031G02 client software supports T6031ABR server software and
previous DSM/SCM server software (including T6031D31). To install the
DSM/SCM client, see Appendix B, Installing the Latest DSM/SCM SPRs and Client
Software.
•
If you have to fall back to a previous RVU and a pre-T6031D46^ABK product
version of DSM/SCM, you must run the T6031ABR FALLBACK macro even if you
have installed previous T6031D46 SPRs. You can export the FALLBACK macro
from the DSM/SCM Archive before you perform a system load or you can use the
FUP DUP command.
SWID
Install the Software Identification (SWID) product (T9298G02) with the DSM/SCM
SPRs before receiving the SUT. See Appendix B, Installing the Latest DSM/SCM SPRs
and Client Software. Download this SPR even if you have already installed an interim
SWID product (T9298D40^AAM).
DSM/SCM and the G06.28 RVU
Starting with the G06.18 RVU, a new configuration file, A7CINFO, is introduced for
managing OSS files. Install the T6031ABR or later SPR on the host system before
receiving the SUT. The corresponding client version of the software must also be
installed.
To upgrade the DSM/SCM client, download the DSM/SCM client version from the
ZDSMSCM subvolume from the SUT and install it. (If you have acquired new system
consoles, the most up-to-date DSM/SCM client is already installed.) For download and
installation instructions for both the server-side and client-side (Planner Interface), see
Appendix B, Installing the Latest DSM/SCM SPRs and Client Software.
Note. All OSS SUT-based products with pax files must have the A7CINFO file in their distributed
subvolumes (DSVs) to be installed by DSM/SCM. Check the appropriate product softdocs and the
Interactive Upgrade Guide 2 to ensure that DSM/SCM installation is possible.
Using PINSTALL/COPYOSS, you can still install OSS products that are not released with an A7CINFO
file in their DSVs. See the appropriate OSS manuals.
To ensure that OSS-managed files can be correctly restored in case of a fall back to an earlier RVU, do
not use the PINSTALL /COPYOSS utilities to install those OSS products that DSM/SCM has installed on
an OSS file system.
During the Build/Apply phase to manage OSS files, DSM/SCM indicates which OSS products in a
configuration are not DSM/SCM-enabled. For those OSS products, use PINSTALL/COPYOSS.