G06.28 Software Installation and Upgrade Guide

Contents

G06.28 Software Installation and Upgrade Guide—541688-001

5. Installing the G06.28 RVU

Verify System Operations (continued)

Check Disk Subsystem Status 4-13

Check the Swap File Configuration 4-14

Check the Status of the Spooler Collector 4-15

Check the Tape Drive Status 4-16

Check Products With Possible Regressions 4-16

Record the Current SYSnn 4-17

Back Up Important Files 4-17

5. Installing the G06.28 RVU

Alerts 5-1

Back Up Important Files 5-2

Receive New Software Into the Archive 5-3

Create a New Software Revision 5-8

Build and Apply the New Software Revision 5-13

Print Operator Instructions From the Target Interface (ZPHITI) 5-19

Recovery for Problems Installing the G06.28 RVU 5-22

Cancel Pending Build/Apply Requests 5-22

6. Replacing the Disk Bootstrap Microcode (Pre-G06.06)

7. Updating Service Processor (SP) Firmware

Alerts 7-2

Before You Begin 7-3

Determine the Current and New Versions of SP Firmware 7-4

Verify That Your Current RVU Is Running the Correct Version of SP Firmware

(Using TSM) 7-5

If Necessary, Reset the SPs Before Updating SP Firmware

7-5

Download the SP Firmware File to the System Console (Optional)

7-6

Update SP Firmware Using the TSM Service Application 7-8

Determining If a Problem Has Occurred 7-15

Verify the Firmware Is Updating (Using TSM) 7-15

Problems Updating SP Firmware (Using TSM) 7-15

Other Indications of SP Firmware Update Problems 7-16

Problems Resetting an SP (Using TSM) 7-16

Recovery for Problems Updating SP Firmware (Using TSM) 7-16

If an SP Firmware Update Fails 7-16

Checking the State of the Service Connection 7-17

Correcting a Failed SP Firmware Update (Using TSM) 7-17

Updating Firmware Using the TSM Low-Level Link Application (Optional) 7-18