G06.28 Software Installation and Upgrade Guide

Overview of Installing G06.28

G06.28 Software Installation and Upgrade Guide—541688-001

1-39

Safeguard

Starting with G06.25 RVU, you must not manually include Safeguard in the OSIMAGE.

Otherwise, a TACL prompt does not appear.

To configure the Safeguard software to run continuously from the time the system is

loaded until the time it is stopped, add the Safeguard software as a persistent process

to the Kernel subsystem. You must specify STARTUP=SYSTEM rather than KERNEL

when using the persistence manager with Safeguard. If you do not specify

STARTUP=SYSTEM and if your audit trails are not on $SYSTEM and no other

volumes are up, auditing is suspended. When the system is started, you must

intervene to resume auditing volumes. For detailed information on this and other

optional Safeguard installation procedures, see the T9750AER softdoc and the

Safeguard Administrator's Manual, Section 10.

There are considerations for possible fallback to a pre-G06.25 Safeguard T9750 SPR.

Compatibility with previous Safeguard SPRs is maintained. However, if the T9750AER

SPR is installed and the DISKFILE-PATTERN feature is used, you must evaluate if

equivalent nonpattern protection records are required after fallback. See the

T9750AER or later softdoc for details.

Starting in G06.26, if you have Safeguard volume-protection records added to prevent

or allow creation of OSS files, they are no longer required for OSS file creation. The

volume protection records can be revised or removed, depending on how they were

designed. If the volume protection records exist as part of a Guardian security policy

and have to be modified to accommodate OSS, the accommodations can now be

removed. For fallback information, see the Interactive Upgrade Guide 2.

S78000 G06.24 S78000 CRUs must be removed. These PMF

CRUs are supported for G06.16 and later

RVUs only. See the Interactive Upgrade Guide

2 for details.

S78000SE G06.25 S78000 CRUs must be removed. These PMF

CRUs are supported for G06.16 and later

RVUs only. See the Interactive Upgrade Guide

2 for details.

S88000 G06.24 S88000 CRUs must be removed. These PMF

CRUs are supported for G06.24 and later

RVUs only. See the Interactive Upgrade Guide

2 for details.

S88000SE G06.25 S88000SE CRUs must be removed. These

PMF CRUs are supported for G06.24 and

later RVUs only. See the Interactive Upgrade

Guide 2 for details.

Table 1-9. Upgrading to NonStop S-Series CRUs and Falling Back (page 2 of 2)

NonStop PMF CRU

Introduced in

this RVU Action