G06.28 Software Installation and Upgrade Guide

Contents

G06.28 Software Installation and Upgrade Guide—541688-001

10. Running ZPHIRNM (continued)

Drain the Spooler 10-3

Back Up the Spooler Control Files 10-4

ZPHIRNM 10-4

Using ZPHIRNM PREVIEW Mode 10-4

Steps for Running ZPHIRNM 10-5

Verify That ZPHIRNM Ran Successfully 10-9

11. Loading the G06.28 RVU

Alerts 11-1

Halt the Processors 11-2

Replace Processor or Other System CRUs 11-3

System Load Using the TSM or OSM

Low-Level Link 11-4

Reload the Remaining Processors (If Necessary) 11-6

Check the Status of the Processors 11-7

Recovery Operations for System Load 11-7

Performing a System Load From the Mirror System Disk 11-7

The Reset Operation 11-8

12. Resuming Normal Operations

Update TCP/IP Configuration Files 12-1

Step 1: Copy the Sample TCP/IP Files Into $SYSTEM.ZTCPIP (Optional) 12-2

Step 2: Check the PROTOCOL File 12-3

Step 3: Ensure That PORTCONF and SERVICES Files Are Complete 12-3

Reconfigure System Console Applications 12-4

Using TSM to Reconfigure Primary and Backup Dial-Out Points

12-4

Using TSM to Reconfigure Your Site Contact Information

12-4

Using OSM (If Installed) to Reconfigure Site Contact Information and Backup Dial-

Out Points 12-4

Check Processor Status (Using TSM or OSM) 12-4

Perform Other Firmware Updates 12-5

Update SWAN and SWAN 2 CLIP Firmware 12-5

Update NonStop ServerNet Switch Firmware 12-5

Update ServerNet Adapter Firmware 12-5

Update ServerNet/FX and ServerNet/FX2 Firmware 12-6

Configure the Spooler 12-9

Start User and System Applications 12-10

Before Starting DSM/SCM 12-10

Start DSM/SCM 12-11