G06.28 Software Installation and Upgrade Guide

Preparing to Upgrade the Server Software

G06.28 Software Installation and Upgrade Guide—541688-001

4-4

Verify System Operations

Verify the integrity of your current system environment to ensure your system is

operating normally before you install the G06.28 RVU by checking Table 4-1.

Check Processor Status (Using Either TSM or OSM)

Check Processor Status (Using TSM)

Verify that the NonStop operating system is running in all processors. (The following

illustrations assume that TSM has been installed from the CD Installer S7X-

SWV1/HNSC-SWV1, Update 7.

1. If necessary, log on to the TSM Low-Level Link Application and perform a System

Discovery.

Table 4-1. Verify System Operations

Steps Activity Done?

Check Processor Status (Using Either TSM or OSM)

Using TSM

Using OSM

Check Critical System Processes

Using TSM

Using OSM

Check the Status of the SACs

4. Check Disk Subsystem Status

5. Check the Swap File Configuration

6. Check the Status of the Spooler Collector

7. Check the Tape Drive Status

8. Check Products With Possible Regressions