G06.29 Software Installation and Upgrade Guide

Preparing to Upgrade the Server Software

G06.29 Software Installation and Upgrade Guide—542744-003

4-16

Check the Status of the Spooler Collector

Check that the spooler collector is active and not 100 percent full.

At a TACL prompt, start SPOOLCOM and issue a COLLECT, STATUS command. For

example:

1> spoolcom $spls; collect, status

COLLECT STATE FLAGS CPU PRI UNIT DATA FILE %FULL

$S ACTIVE 3 , 1 154 4 $OPS0.SPL.DATA 44

Check the Tape Drive Status

Check that the tape drive to be used to install the SUT is started and online:

1. At a TACL prompt, enter:

> SCF STATUS TAPE $*

2. Verify that the STATUS TAPE display includes the tape subsystem you plan to use

to load the SUT. For example:

STORAGE - Status TAPE \ELI.$SILO2

LDev State Primary Backup DeviceStatus

PID PID

138 STARTED 0,295 1,279 ONLINE

3. If the tape subsystem you plan to use is not listed, select another tape drive or add

the tape drive to your system configuration. The state of that tape drive must be

STARTED, and the device status must be ONLINE.

4. If the status of the tape drive is stopped or not ready, start the tape drive and put

the tape drive online.

Check Products With Possible Regressions

Check products that might experience regression during the upgrade. These products

include Spooler Plus (T9593), Enform Plus (T0295), and CRE/RTL (T1269). If these

products are present in your current configuration, take the recommended action after

the upgrade is complete.

Spooler Plus (T9593)

Enter the following command to determine if Spooler Plus has been bound into the

Spool object:

VPROC $SYSTEM.SYSTEM.SPOOL

If Spooler Plus has been bound into the Spool object, the VPROC output appears

similar to:

Version Procedure: T9593D41^10MAY99^IPM^T9593AAD