G06.29 Software Installation and Upgrade Guide

Updating Processor Boot Code
G06.29 Software Installation and Upgrade Guide—542744-003
8-16
Reset the Processors To Complete Updating the
Processor Boot Code (Both for OSM and TSM)
When you change the Filter by list from Y-side to X-side, this message appears:
Changing a required filter results in your
selections being cleared.
Do you still wish to change the filter?
12. Click OK.
13. Click Add All to add the SPs you want to update to the Processor Boot Millicode
Firmware lower list.
14. Click Perform Action.
15. Click OK when the Confirm Processor Boot Millicode Firmware Update dialog box
appears.
The Processor Parameter Input dialog box appears.
16. Enter the file location. Use the $volume.subvolume.filename created during
the most recent DSM/SCM Build/Apply and click OK. For example:
$system.sys02.cpucode9
As the firmware update is performed, information about it appears in the Progress
List.
17. To verify that firmware updates are in progress, select Action Summary. The
Action Status Summary window appears with information about recent actions,
including their status and overall progress.
You must now reset the processors using either the Reset option or Start System from
the TSM or OSM Low-Level Link. See Reset the Processors To Complete Updating
the Processor Boot Code (Both for OSM and TSM).
Reset the Processors To Complete Updating the Processor Boot
Code (Both for OSM and TSM)
You must perform a Reset action or equivalent (Start System in the OSM or TSM Low-
Level Link) of the processors after you have updated the processor boot code and if
you did not select the explicit online boot code option in either TSM or OSM. Use the
Reset action from either the OSM or TSM Low-Level Link. The Reset operation
terminates all processes running on a processor, stops the processor, and places the
processor in a known state, ready for a Prime for Reload or Load action.
1. Log on to the server using the OSM Low-Level Link or TSM Low-Level Link
Application.
2. On the toolbar, click Processor Status.
Note. You can also perform an equivalent action using the TSM or OSM Low-Level Link on all
processors when you perform a Start System. See System Load Using the TSM or OSM Low-
Level Link on page 11-4 and, for more information on Reset, see The Reset Operation on
page 11-8.