G06.29 Software Installation and Upgrade Guide

Running ZPHIRNM

G06.29 Software Installation and Upgrade Guide—542744-003

10-5

Steps for Running ZPHIRNM

Note: TMF is not required to be running during the real ZPHIRNM

because no SQL program files need to be renamed.

PREVIEW mode also reveals most errors that ZPHIRNM would encounter if it were

run. If errors are revealed, you can evaluate and correct them interactively.

The syntax for running ZPHIRNM in PREVIEW mode is (from the DSM/SCM

subvolume):

> RUN ZPHIRNM [$vol.]SYSnn , PREVIEW [STRICT] [,option] ...

If you enter a RUN ZPHIRNM command with no arguments, ZPHIRNM help text

displays information about PREVIEW mode. For more information, see the DSM/SCM

User’s Guide.

Steps for Running ZPHIRNM

1. At a TACL prompt, enter this command from the DSM/SCM subvolume:

> RUN ZPHIRNM $vol.SYSnn

where:

•

$vol specifies the default current system load volume, usually $SYSTEM.

•

SYSnn specifies the subvolume to which you just applied software. The SYSnn

subvolume must match the activation SYSnn that you specified earlier during

the Build/Apply phase.

2. When asked if you want to use a log file with the session, enter Y.

3. When prompted, enter a file name for the log file.

For example:

6> run zphirnm $system.sys00

DSM/SCM Utility - ZPHIRNM - T6031G02 - (27FEB2005)

Do you want to use a log file with this session? (Y/N): n

You may use any file for logging. If you request to use a

disk

file that doesn't exist, it will be created as an edit file.

Please enter a filename: elist00

Log file is open, Zphirnm will now begin processing.