G06.29 Software Installation and Upgrade Guide

Running ZPHIRNM
G06.29 Software Installation and Upgrade Guide—542744-003
10-9
Verify That ZPHIRNM Ran Successfully
5. If necessary, you can compare the creation dates of the whatis file to the whatis_old
file to see if any changes occurred:
a. Run the more command against the whatis file:
more /usr/share/man/whatis
b. After reviewing the displayed file, exit by entering the letter q at the percentage
(%) prompt.
c. Repeat Steps a. and b. for the whatis_old file.
Verify That ZPHIRNM Ran Successfully
1. Review the log file.
2. If ZPHIRNM did not run successfully, correct whatever problems occurred and run
it again.
Two types of error and warning messages are issued during the renaming process:
•
If a fatal error occurs, ZPHIRNM immediately issues an error message and
stops.
•
If a nonfatal error occurs, ZPHIRNM issues an error message and attempts to
restore the subvolume it is currently processing to its original state. A nonfatal
error is one that affects processing only for a single subvolume.
°
If the subvolume is successfully restored, ZPHIRNM continues with the
next subvolume.
°
If the subvolume cannot be restored, ZPHIRNM issues an additional error
message and continues with the next subvolume.
°
If the subvolume was successfully processed, you can ignore warning
messages.
For troubleshooting procedures, see the DSM/SCM User’s Guide. For a complete
list of ZPHIRNM messages, see the DSM/SCM Messages Manual.