G06.29 Software Installation and Upgrade Guide

Updating SWAN Concentrator CLIP Firmware
G06.29 Software Installation and Upgrade Guide—542744-003
C-8
Using the TSM Firmware Update Dialog Box to
Update SWAN Firmware
To stop the SWAN adapter object, you can also enter the SCF STOP
command. For example:
12> SCF STOP ADAPTER $ZZWAN.#51, SUB ALL
c. Check if the SWAN adapter is stopped in TSM or use the SCF STATUS
SERVER command:
13> SCF STATUS SERVER $ZZWAN.#51.*
5. After the SWAN objects are stopped, try to update the SWAN CLIPs again.
If you are still having trouble stopping the SWAN object, see Support Note S04029
and the SWAN Concentrator and WAN Subsystem Troubleshooting Guide topic
“Correcting SWAN Concentrator Hardware Problems.”
If you still have trouble using the guided procedure, see Step 3: Initiate the Firmware
Update Using TSM on page C-17 to update the SWAN firmware.
Using the TSM Firmware Update Dialog Box to
Update SWAN Firmware
The firmware version format of SWAN CLIPs running T7953AAO is:
T7954Vnn^ddmmmyyyy^AAO
Alert
If you need to fall back to a previous G-series RVU, do not fall back to pre-T7953AAG
versions of SWAN CLIP firmware or a pre-T7909AAK version of the WANBOOT
product. The newer product versions are compatible with the earliest G-series RVUs
and contain important fixes and enhancements.
Before Updating SWAN CLIP Firmware
1. List the Names of the SWAN Concentrators and CLIPs.
2. Check Location and Version of New SWAN CLIP Firmware.
3. Check Firmware Version Currently Running in SWAN CLIPs.
Note. The instructions in this appendix require that you have performed a system load of the
G06.29 RVU and, as a result, are running the latest version of the WANBoot process (T7909)
and its requisites (WANMgr [T8365], WAN SCF Product Module [T7925], and ConMgr
[T7922]).