G06.29 Software Installation and Upgrade Guide

Overview of Installing G06.29
G06.29 Software Installation and Upgrade Guide—542744-003
1-47
SCF Storage Subsystem (Online Disk Remirroring)
For more information on proper shutdown of the spooler, see Support Notes S97057
(T9101D41 Spooler Collector Data Files Have Changed Format) and S99086 (NSK
Spooler—Migration and Draining Instructions).
CSPOOL Set at HIGHPIN
Beginning with G06.19, a new spooler SPR, T9101D48^AEY, is introduced. This SPR
is installed by DSM/SCM with CSPOOL at HIGHPIN. If you do not want this setting,
you can change CSPOOL to use LOWPIN by issuing the BINDER command:
CHANGE HIGHPIN OFF IN CSPOOL
SCF Storage Subsystem (Online Disk Remirroring)
Beginning with G06.21, OSM automatically recognizes online remirrored disks.
However, you cannot perform online reconfiguration of a mirror drive while TSM
($ZTSM) is running. You must always stop the TSM server process before you
implement online disk remirroring (ODR). After issuing SCF commands for ODR,
restart the TSM server.
During the ODR operation when using TSM, error 00012 might appear. For cause and
recovery information, see Appendix B in the SCF Reference Manual for the Storage
Subsystem.
For detailed descriptions of using SCF commands to configure ODR, see the SCF
Reference Manual for the Storage Subsystem.
SWID (T9298G02)
Restore and Receive Before Upgrading
SWID is the software identification utility invoked by the SYSGENR program that audits
file identification information about your software. You must restore and receive the
new SWID PVU before you install the G06.29 SUT. See Copy (RESTORE) the
T6031ABU DSM/SCM Product Version and SWID to Disk on page B-5.
Tandem Failure Data System (TFDS)
Check that TFDS is configured properly on the system. (TFDS monitors processors in
NonStop servers for software failure notifications.) The dump volume should not be
protected by Safeguard and should also be properly configured.
Note. DSM/SCM automatically sets CSPOOL to HIGHPIN and automatically overlays the
current object file CSPOOL with the original from the SUT whenever a subsequent Build/Apply
is performed. See Support Note S03006A.