G06.30 Software Installation and Upgrade Guide

Updating Service Processor (SP) Firmware
G06.30 Software Installation and Upgrade Guide—543764-002
7-12
Update SP Firmware Using the TSM Service
Application
The update starts, and the Firmware Update Action Summary dialog box appears.
Updating each service processor takes approximately ten
minutes, and updating a master service processor takes
approximately twenty minutes.
13. Monitor the status of the service processor firmware update in the Firmware
Update Action Summary dialog box.
a. Verify that the firmware update for every SP on the chosen fabric (X or Y) has
started.
b. Verify that the status of all SPs changes to Completed.
14. Click Yes when asked if you want to reset all SPs that were successfully updated:
All of the service processor (SP) firmware updates have completed
successfully.
In order for the firmware to be used, a reset must be performed on each SP.
Answering “Yes” will automatically reset all successfully updated SPs in
this group.
Answering “No” will require each SP to be individually reset.
If the master service processor (MSP) is reset, you might lose the Compaq
TSM service connection with the S-series server. Use the System “Session
Responsive Test” action to determine if your current service connection is
active.
Do you want to automatically reset all successfully updated SPs in this
group?
15. Click OK when you are notified that all the SPs have been successfully reset:
All service processors (SPs) that had firmware updates applied have been reset successfully.
The Firmware Update Action Summary dialog box confirms that the SPs have
been reset. For example:
VST647.vsd