G06.30 Software Installation and Upgrade Guide

Updating Service Processor (SP) Firmware
G06.30 Software Installation and Upgrade Guide—543764-002
7-19
Resetting an SP Using the TSM Low-Level Link
Application
6. Click OK when the warning message appears:
This action takes up to 2 minutes for the SP to complete the reset even if
the action appears to complete immediately.
This action will cause any Firmware Update actions against this SP to
abort.
Verify there are no Firmware Updates being performed on this SP before
continuing.
Are you sure you want to reset this SP?
7. When the status of the reset action appears as Completed in the Action Status
box, click Refresh to update the information in the Service Processors (SPs) list.
For example:
8. Verify that the correct version of SP firmware appears in the Service Processors
(SPs) list.
9. Click Close.