G06.30 Software Installation and Upgrade Guide

Installing the Latest DSM/SCM SPRs and Client
Software
G06.30 Software Installation and Upgrade Guide—543764-002
B-14
Alert (DSM/SCM T6031G02 Client)
If you are using DSM/SCM to manage OSS file options, you must install the DSM/SCM
client software.
DSM/SCM T6031ABZ client software supports DSM/SCM server software (including
T6031D31). If you have to fall back, you can use the newly installed client software, but
you should revert back to the previous DSM/SCM PVU.
Alert (DSM/SCM T6031G02 Client)
Do not attempt to use DSM/SCM T6031G02 client software until you have first installed
the T6031ABZ SPR on your host system. See Table 3-1 on page 3-5.
Limited DSM/SCM operation is available if you run T6031G02 client software with
pre-AAO server software. HP recommends that both the DSM/SCM product version
and DSM/SCM client be at the same version level at all times.
Determine Your DSM/SCM Client Software Version
To determine which version of DSM/SCM client software is installed, start the
DSM/SCM Planner Interface. Before prompting you to log on, the About DSM/SCM
window briefly displays version information. See Determine the Product Version of
DSM/SCM on the Host System on page B-4.
Determine the Current IP Address and Port Number
When you install DSM/SCM client software, you are prompted to enter the IP address
of the host system with which DSM/SCM communicates and the IP port number for the
DSM/SCM Winsock service.
If the DSM/SCM client software on your system console is configured to communicate
with a host system, determine the configured IP address and port number:
1. Start Windows Explorer. Open My Computer if not already open.
2. Double-click the hard drive icon to display its contents.
3. Open the DsmScm folder to display its contents.
4. In the Contents pane, double-click dsmscm.ini.
Note. Before you begin client installation:
•
Back up your current DSM/SCM folder to save the configuration information and the
Planner Interface version.
•
Check that unnecessary PC programs are not running and that no DSM/SCM Build or
Applies are in progress.