G06.30 Software Installation and Upgrade Guide

Contents

G06.30 Software Installation and Upgrade Guide—543764-002

9. Updating SCSI Boot Code (Pre-G06.08 RVU)

SCSI Boot Code Product Numbers 9-1

Using TSM to Update SCSI Boot Code (If Necessary) 9-2

Using OSM to Update SCSI Boot Code (If Necessary) 9-4

10. Running ZPHIRNM

Alerts 10-1

Back Up (Copy) Files in the $SYSTEM.ZTCPIP Subvolume 10-2

Stop All Applications 10-3

Drain the Spooler 10-3

Back Up the Spooler Control Files 10-4

ZPHIRNM 10-4

Using ZPHIRNM PREVIEW Mode 10-4

Steps for Running ZPHIRNM 10-5

Verify That ZPHIRNM Ran Successfully 10-9

11. Loading the G06.30 RVU

Alerts 11-1

Halt the Processors 11-2

Replace Processor or Other System CRUs 11-3

System Load Using the TSM or OSM

Low-Level Link 11-4

Reload the Remaining Processors (If Necessary) 11-6

Check the Status of the Processors 11-7

Recovery Operations for System Load 11-7

Performing a System Load From the Mirror System Disk 11-7

The Reset Operation

11-8

12. Resuming Normal Operations

Update TCP/IP Configuration Files 12-1

Step 1: Copy the Sample TCP/IP Files Into $SYSTEM.ZTCPIP (Optional) 12-2

Step 2: Check the PROTOCOL File 12-3

Step 3: Ensure That PORTCONF and SERVICES Files Are Complete 12-3

Reconfigure System Console Applications 12-4

Using TSM to Reconfigure Primary and Backup Dial-Out Points 12-4

Using TSM to Reconfigure Your Site Contact Information 12-4

Using OSM (If Installed) to Reconfigure Site Contact Information and Backup Dial-

Out Points 12-4

Check Processor Status (Using TSM or OSM) 12-4