G06.30 Software Installation and Upgrade Guide

G06.30 Upgrade Checklists
G06.30 Software Installation and Upgrade Guide—543764-002
2-2
G06.30 Upgrade Checklist
8. Receive G06.30 RVU
SUT into the DSM/SCM
software archive
33 minutes
(Full SUT,
all
products)
Receive New Software Into the
Archive on page 5-3 and follow
Alerts
on page 5-1.
9. Install and configure
TSM or OSM SPRs
(optional)**
40
minutes***
See the OSM Migration and
Configuration Guide and TSM
softdocs.
10. Create G06.30 software
configuration revision
1 minute Create a New Software Revision
on page 5-8
11. Build and apply G06.30
software revision
2 hours
with OSS
files
Build and Apply the New Software
Revision on page 5-13
12. Print the DSM/SCM
Operator Instructions
<1 minute Print Operator Instructions From
the Target Interface (ZPHITI) on
page 5-19
13. Replace the disk
bootstrap program (if
necessary)
<1 minute Section 6, Replacing the Disk
Bootstrap Microcode (Pre-G06.06
RVU)
14. Update ME firmware (if
necessary)
5 minutes See the OSM online help
15. Update service
processor (SP) firmware
(if necessary)
9 minutes
per SP
Section 7, Updating Service
Processor (SP) Firmware
16. Update processor boot
code (if necessary)
0.0
minutes
**
Section 8, Updating Processor
Boot Code
17. Update ME and other
firmware
30 minutes
18. Run ZPHIRNM 12 minutes Running ZPHIRNM
on page 10-1
19. Halt processors 4 minutes Halt the Processors on page 11-2
20. Load the system with the
G06.30 RVU
10 minutes System Load Using the TSM or
OSM Low-Level Link on
page 11-4
21. Update SCSI boot code
(if necessary)
1 minute
per
controller
Section 9, Updating SCSI Boot
Code (Pre-G06.08 RVU)
22. Recover the TCP/IP files
(if necessary)
2 minutes Update TCP/IP Configuration
Files on page 12-1
23. Reconfigure TSM or
OSM ND applications (if
necessary)
0.0
minutes
***
Reconfigure System Console
Applications on page 12-4
Table 2-1. G06.30 Upgrade Checklist (page2of3)
Task Description
Minimum
Duration Documentation Done?