G06.31 Software Installation and Upgrade Guide

G06.31 Software Installation and Upgrade Guide—544626-002
13-1
13 Resuming Normal Operations
Several tasks must be performed after system load before you resume normal system
operations, as described in this section.
•
Update TCP/IP Configuration Files on page 13-1
•
Check Processor Status (Using TSM or OSM) on page 13-4
•
Perform Other Firmware Updates on page 13-5
•
Configure the Spooler on page 13-9
•
Start User and System Applications on page 13-10
•
Reset and Start the Mirror System Disk (If Necessary) on page 13-11
•
Configure Specific Products (Post-System Load) on page 13-12
°
Start DSM/SCM on page 13-11
°
Configure Expand and New Profiles on page 13-12
°
Configure OSS on page 13-13
°
Configure SMF (Optional) on page 13-15
°
Configure the Remote Database Facility (RDF) on page 13-15
°
Upgrade the WAN Manager (T8365) (Optional) on page 13-16
°
Upgrade the TNOS Server and TNOS Utility (Optional) on page 13-16
°
Configure Spooler Plus and Enform Plus on page 13-16
Update TCP/IP Configuration Files
Note. You must have all the TCP/IP configuration files in your $SYSTEM.ZTCPIP subvolume.
Otherwise, applications dependent on proper network connections will fail.
Alerts:
•
See Back Up (Copy) Files in the $SYSTEM.ZTCPIP Subvolume on page 11-2.
•
For the DSM/SCM Planner Interface to be operational, the PORTCONF file must have the
correct entry for DSM/SCM. The SERVICES file must have an entry that specifies DSM
and its corresponding port number.
•
Keep your current PROTOCOL file in your $SYSTEM.ZTCPIP subvolume. Update it with
the new lines from the sample PROTOCOL file (SMPLPROT).