G06.31 Software Installation and Upgrade Guide

Contents

G06.31 Software Installation and Upgrade Guide—544626-002

10. Updating SCSI Boot Code (Pre-G06.08 RVU)

SCSI Boot Code Product Numbers 10-1

Using TSM to Update SCSI Boot Code (If Necessary) 10-2

Using OSM to Update SCSI Boot Code (If Necessary) 10-4

11. Running ZPHIRNM

Alerts 11-1

Back Up (Copy) Files in the $SYSTEM.ZTCPIP Subvolume 11-2

Stop All Applications 11-3

Drain the Spooler 11-3

Back Up the Spooler Control Files 11-4

ZPHIRNM 11-4

Using ZPHIRNM PREVIEW Mode 11-4

Steps for Running ZPHIRNM 11-5

Verify That ZPHIRNM Ran Successfully 11-9

12. Loading the G06.31 RVU

Alerts 12-1

Halt the Processors 12-2

Replace Processor or Other System CRUs 12-3

System Load Using the TSM or OSM

Low-Level Link 12-4

Reload the Remaining Processors (If Necessary) 12-6

Check the Status of the Processors 12-7

Recovery Operations for System Load 12-7

Performing a System Load From the Mirror System Disk 12-7

The Reset Operation 12-8

13. Resuming Normal Operations

Update TCP/IP Configuration Files 13-1

Step 1: Copy the Sample TCP/IP Files Into $SYSTEM.ZTCPIP (Optional) 13-2

Step 2: Check the PROTOCOL File 13-3

Step 3: Ensure That PORTCONF and SERVICES Files Are Complete 13-3

Reconfigure System Console Applications 13-4

Using TSM to Reconfigure Primary and Backup Dial-Out Points 13-4

Using TSM to Reconfigure Your Site Contact Information 13-4

Using OSM (If Installed) to Reconfigure Site Contact Information and Backup Dial-

Out Points 13-4

Check Processor Status (Using TSM or OSM) 13-4