G06.31 Software Installation and Upgrade Guide

Installing SPRs Before Upgrading to the G06.31
RVU
G06.31 Software Installation and Upgrade Guide—544626-002
4-8
DSAP/DCOM
•
T1052G10^ABJ (if using SQL/MX)
•
T9753G07^AGB (I/O drivers)
•
T9543G08^ABJ (DSAP/DCOM)
Falling back to G06.23 or earlier RVUs is not supported.
DP2 has a dependency on DSAP/DCOM. If you install the DP2 fallback SPR
(T9053AQS), you must also install T9543G08^ABJ.
For more information on Format 2 files and the OSS Large Files feature, see OSS
Files Greater Than 2 Gigabytes (Large Files) on page 2-5.
DSAP/DCOM
The DSAPDDL file is changed in the product revision of DSAP/DCOM delivered in the
G06.29 RVU (T9543G08^ABJ), resulting in changes to the work-file layout. You must
use the DSAPDDL file distributed with T9543G08^ABJ when running ENFORM
queries on the work file created using this SPR. For details, see DSAP/DCOM
Migration and Fallback on page 2-6.
The product revision of DSAP/DCOM delivered in the G06.29 RVU (T9543G08^ABJ) is
“large OSS file safe”, but product revisions delivered in earlier RVUs are not. The
aforementioned migration considerations apply. If you fall back from G06.29 to an
earlier RVU, HP recommends that you install T9543G08^ABJ during the fallback.
Backup and Restore 2
If you have a tape file with a mix of OSS files smaller than 2 GB and larger than 2 GB
that needs to be restored to a G06.23 to G06.28 file set that does not support files
larger than 2 GB, install the following SPRs to restore files smaller than 2 GB and skip
files larger than 2 GB:
SPR Product
T2721G06^AAL BRCOM
T2722G06^AAL BR2 Tape Services
T2749G06^AAL BR2 DMA and CSP
T2750G06^AAL BR2 Data Service
T9055G11^AFI FILSYS (G06.23 - G06.26) (see following note)
T9055G12^AFJ FILSYS (G06.27) (see following note)
Note. The T9055 compatibility SPR is preinstalled on the G06.28 SUT.