G06.31 Software Installation and Upgrade Guide

Installing SPRs Before Upgrading to the G06.31

RVU

G06.31 Software Installation and Upgrade Guide—544626-002

4-10

RDF Interoperability SPRs

The SPRs listed in Table 4-5 enable RDF on a node running an RVU prior to G06.00 or

D46.00 to interoperate with RDF on a node running a G06.00 or later or D46.00 or later

RVU. The RDF interoperability SPR must be applied to the down-level node as a part

of the migration of any other node in the RDF environment to a G06.00 or later

G-series, or D46.00 or later D-series, RVU.

SQL AUDSERV Interoperability SPRs

SQL AUDSERV is the product that executes SQL Online DDL modification commands,

such as MOVE (Partition) WITH SHARED ACCESS.

For migration issues regarding format 2 files, including any interoperability issues

regarding SQL AUDSERV, see the Interactive Upgrade Guide 2.

OSM Server and Client Compatibility SPRs

After you have performed a system load and run your system tests, you can install,

configure, and use OSM. For migration information, including server and console

requirements, see the

OSM Migration and Configuration Guide

For descriptions of the tasks for which the OSM Service Connection, rather than the

TSM Service Connection, should be used, see OSM and TSM on page 1-5.

Starting at G06.25, OSM SPR T0682 replaces all eight individual server-based SPRs

that comprised OSM on G06.24 and previous RVUs. During migration from a pre-

G06.25 to G06.25 or later RVU, DSM/SCM automatically identifies the eight OSM

SPRs that have been dropped from the SUT because they are replaced by T0682. For

more information, see the

OSM Migration and Configuration Guide

For G06.31, the latest OSM SPR is T0682G07^ABA. The G06.31 OSM client-based

SPRs are:

•

T0632AAU (OSM Notification Director)

Note. Interoperability support exists in various earlier SPRs, but HP recommends that you use

the most current SPRs, because they contain several important corrections to the

interoperability support.

Table 4-5. RDF Interoperability SPRs

If a primary or backup node

within the RDF environment

is running this RVU...

And any other node in the RDF environment is

upgraded to a G06.00 or later or D46.00 or later RVU,

install this (or a superseding) SPR on the down-level

node...

D32.00 through D39.00 T5864ABD

D42.00 through D45.00 T5864ABE

G02.00 through G05.00 T5864ABE