G06.32 Software Installation and Upgrade Guide

Installing SPRs Before Upgrading to the G06.32
RVU
G06.32 Software Installation and Upgrade Guide—546068-002
4-12
RDF Interoperability SPRs
RDF Interoperability SPRs
The SPRs listed in Table 4-6 enable RDF on a node running an RVU prior to G06.00 or
D46.00 to interoperate with RDF on a node running a G06.00 or later or D46.00 or later
RVU. The RDF interoperability SPR must be applied to the down-level node as a part
of the migration of any other node in the RDF environment to a G06.00 or later
G-series, or D46.00 or later D-series, RVU.
T9276 AAW Axcel Required to recognize OCA region G06.27
T0448 AAA OCA Required to prepare TNS code
files to run accelerated on a
NonStop BladeSystem
G06.27
T6031 ABP DSM/SCM Required to enable customers to
receive J-series SUTs, and install
and manage software on a
NonStop BladeSystem target from
a NonStop S-series host (available
to be applied to the G06.26 RVU
and compatible to G06.21). The
functions in T6031ABP and
T9298AAM are included in the
G02 DSM/SCM and SWID product
version updates releasing in
G06.27 and later
Released post
G06.26 and is
backwards
compatible to
G06.21. Also, the
G02 SPR (installed
with G06.27 and
later) meets the
requirements.
Note. Interoperability support exists in various earlier SPRs, but HP recommends that you use
the most current SPRs, because they contain several important corrections to the
interoperability support.
Table 4-6. RDF Interoperability SPRs
If a primary or backup node
within the RDF environment
is running this RVU...
And any other node in the RDF environment is
upgraded to a G06.00 or later or D46.00 or later RVU,
install this (or a superseding) SPR on the down-level
node...
D32.00 through D39.00 T5864ABD
D42.00 through D45.00 T5864ABE
G02.00 through G05.00 T5864ABE
Table 4-5. Interoperability SPRs for NonStop BladeSystems and NonStop S-
Series Systems (continued) (page 2 of 2)
Minimum
SPR
Product
Name Description
Introduced in this
RVU