G06.32 Software Installation and Upgrade Guide

Contents
G06.32 Software Installation and Upgrade Guide—546068-002
ix
17. Running ZPHIRNM to Reactivate the Previous
Software Revision
17. Running ZPHIRNM to Reactivate the Previous Software
Revision
Alerts 17-1
Drain the Spooler 17-1
Run ZPHIRNM 17-2
Using PREVIEW Mode
17-2
Run ZPHIRNM
17-2
Verify That ZPHIRNM Ran Successfully 17-3
18. Loading the Previous RVU and Resuming Normal
Operations
Alerts 18-1
Prepare to Stop the System 18-2
Halt the Processors 18-2
Remove Hardware Installed During Migration 18-2
Perform a System Load With the Previous SYSnn and CONFxxyy 18-3
Reload the Remaining Processors 18-3
Resume Normal Operations 18-4
Configure Spooler 18-5
Reconfigure DSM/SCM User IDs (If Necessary) 18-5
A. Using DSM/SCM to Install SPRs
Tools for Managing SPRs A-1
Scout for NonStop Servers A-1
DSM/SCM A-2
SPRNOTES
A-2
Install SPRs With DSM/SCM A-2
Save the Current Configuration A-2
Determine the Current SYSnn A-3
Receive the SPR Into the DSM/SCM Archive A-4
Create a New Software Configuration That Includes the SPR A-5
Build the New Revision A-5
Print Operator Instructions From the Target Interface (ZPHITI) A-6
Run ZPHIRNM
A-6
If Running INSTALL^TEMPLATES Is Required
A-7