G06.32 Software Installation and Upgrade Guide

Overview of Installing G06.32
G06.32 Software Installation and Upgrade Guide—546068-002
1-7
SWID
DSM/SCM. The DSM/SCM client and server product version enables you to manage
OSS files and is compatible with systems running H-series RVUs.
•
If you are upgrading to the G06.32 RVU, download the most current client version
of DSM/SCM (T6031G07) from the ZDSMSCM subvolume after the G02 new
product version has been restored and activated from the SUT tape. The
DSM/SCM T6031G07 client software supports T6031G07^ACH server software
and previous DSM/SCM server software (including T6031D31). To install the
DSM/SCM client, see Appendix C, Installing the Latest DSM/SCM SPRs and Client
Software.
•
If you have to fall back to a previous RVU and a pre-T6031D46^ABK product
version of DSM/SCM, you must run the T6031G02 FALLBACK macro even if you
have installed previous T6031D46 SPRs. You can export the FALLBACK macro
from the DSM/SCM Archive before you perform a system load or you can use the
FUP DUP command.
SWID
Install the Software Identification (SWID) product (T9298G02) with the DSM/SCM
SPRs before receiving the SUT. See Appendix C, Installing the Latest DSM/SCM
SPRs and Client Software. Download this SPR even if you have already installed an
interim SWID product (T9298D40^AAM).
DSM/SCM and the G06.32 RVU
Starting with the G06.18 RVU, a new configuration file, A7CINFO, is introduced for
managing OSS files. Install the T6031G07^ACH SPR on the host system before
receiving the SUT. The corresponding client version of the software must also be
installed.
To upgrade the DSM/SCM client, download the DSM/SCM client version from the
ZDSMSCM subvolume from the SUT and install it. (If you have acquired new system
consoles, the most up-to-date DSM/SCM client is already installed.) For download and
installation instructions for both the server-side and client-side (Planner Interface), see
Appendix C, Installing the Latest DSM/SCM SPRs and Client Software
.
Note. All OSS SUT-based products with pax files must have the A7CINFO file in their distributed
subvolumes (DSVs) to be installed by DSM/SCM. Check the appropriate product softdocs and the
Interactive Upgrade Guide 2 to ensure that DSM/SCM installation is possible.
Using PINSTALL/COPYOSS, you can still install OSS products that are not released with an A7CINFO
file in their DSVs. See the appropriate OSS manuals.
To ensure that OSS-managed files can be correctly restored in case of a fall back to an earlier RVU, do
not use the PINSTALL /COPYOSS utilities to install those OSS products that DSM/SCM has installed on
an OSS file system.
During the Build/Apply phase to manage OSS files, DSM/SCM indicates which OSS products in a
configuration are not DSM/SCM-enabled. For those OSS products, use PINSTALL/COPYOSS.