G06.32 Software Installation and Upgrade Guide

Installing the Latest DSM/SCM SPRs and Client
Software
G06.32 Software Installation and Upgrade Guide—546068-002
C-11
Restart Applications
The INSTALL^TEMPLATES macro is located in the $SYSTEM.ZINSAIDS subvolume
and invokes the TEMPLI program to build new resident and nonresident EMS template
files.
You must be logged on as the super ID (255, 255) to run the INSTALL^TEMPLATES
macro. This macro cannot be run with the NOWAIT option and takes approximately ten
minutes to finish.
For detailed instructions on running the INSTALL^TEMPLATES macro, including
troubleshooting information, see If Running INSTALL^TEMPLATES Is Required on
page A-7.
Restart Applications
You can now start your application software. Follow your site’s procedures for
executing the system configuration and startup (command) files to accomplish this.
DSM/SCM is often started automatically by a system command file. If not, you must
start DSM/SCM manually, as described next.
Before Starting DSM/SCM
1. Check that TMF is started:
> TMFCOM STATUS TMF
2. Verify your current configuration against the cold start configuration in PATHHOST
(or PATHTARG) to check that the current configuration reflects all changes you
have made.
3. If necessary, run the PATHCOLD macro from the ZDSMSCM subvolume to cold
start the Pathway configuration.
Start DSM/SCM
1. Run the STARTSCM macro from the ZDSM/SCM subvolume to start DSM/SCM:
> RUN STARTSCM
These messages appear:
Because the $ZHOME reliable home-term process is not an interactive process
and is always paused, no action is necessary.
$TDSV ZDSMSCM 25> startscm
DSM/SCM Process Startup Function - STARTSCM - T6031G02 - (30AUG2005)
Copyright Hewlett Packard Development Company L.P. 1993-2005
NOTICE: * If the hometerm chosen during INITENV, $zhome,
* is not currently in a paused state, STARTSCM and DSM/SCM
* server processes may hang indefinitely. Be sure this
* hometerm has been paused!