G06.32 Software Installation and Upgrade Guide

G06.32 Installation and Fallback Alerts
G06.32 Software Installation and Upgrade Guide—546068-002
2-2
4619 Disk Drives
•
NonStop TCP/IPv6 on page 2-27
•
TMF on page 2-27
•
TNOS Server and TNOS Utility on page 2-29
•
TCP/IP on page 2-29
•
Visual Inspect on page 2-30
•
Volume Protection Records and OSS File Creation on page 2-31
•
X25AM on page 2-31
•
NonStop Secure Shell Server on page 2-32
•
ServerNet Clusters and NonStop BladeSystems on page 2-32
•
DSM Tape Catalog Migration on page 2-32
4619 Disk Drives
You can install the 4619 disk drive in the same system enclosure as disk drives of
different model numbers. However, disk drives in a mirrored volume must always be
the same model number, even if they are of the same capacity. Because of the
difference in rotational speed between the 4618 (10K rpm) and 4619 (15K rpm) disk
drives, place the 4618 and 4619 disk drives in a mirrored volume only during an online
disk replacement procedure.
6780 ServerNet Switch (G06.21)
For information on required software, installation, migration, and fallback procedures,
see the ServerNet 6780 Planning and Installation Guide .
Backup and Restore 2 (BR2) (G06.24 and G06.26)
Backup and Restore 2.0 was introduced at G06.23 and became available on the
G06.24 SUT. It supports OSS and NonStop SQL/MX files and consists of these major
components:
•
Backup and Restore Command Interface (BRCOM) (T2721)
•
Data Service (T2750)
•
Data Management Application (DMA) (T2749)
•
Tape Service (T2722)
For more information on these SPRs, see the Interactive Upgrade Guide 2.
These Backup and Restore 2.0 SPRs support OSS files and SQL/MX objects:
•
BR 2 BRCOM (T2721AAC and later)
•
BR 2 Tape Services (T2722AAC and later)
•
BR 2 DMA & Cmd Stream Proc (T2749AAC and later)
•
BR 2 Data Services (T2750AAC and later)
T2826 has been removed as a requisite SPR.