G06.32 Software Installation and Upgrade Guide

Installing SPRs Before Upgrading to the G06.32
RVU
G06.32 Software Installation and Upgrade Guide—546068-002
4-3
Summary of the SPR Installation Procedure
RVU, use TSM to update the firmware and perform system loads. For descriptions
of the tasks not supported by TSM, see OSM and TSM on page 1-5. After the RVU
migration is complete, OSM might be required to monitor and service new
hardware you are adding to your system. For more information on the latest OSM
SPRs, see OSM Server and Client Compatibility SPRs on page 4-13.
Summary of the SPR Installation Procedure
1. Use Scout to verify that you can apply the DSM/SCM SPR to your current G-series
RVU.
2. Use DSM/SCM to install the required SPRs. For detailed instructions, see
Appendix A, Using DSM/SCM to Install SPRs.
3. Update the firmware or boot code if needed. Update also any Maintenance Entity
(ME) firmware.
4. Use the INSTALL^TEMPLATES macro located in the TACLMACS file to install
EMS template object files from SPRs on a running system if SYSGEN and system
load are not required. If a SYSGEN is required, do not run the
INSTALL^TEMPLATES macro.
5. Run ZPHIRNM.
6. Perform a system load if SYSGEN is required.
7. Update SWAN and other firmware as needed.
DSM/SCM T6031G07^ACH SPR
Since G06.18, you must install both the client and server-side T6031D46 or later
product to manage OSS files. HP recommends that you upgrade to the newest SPR of
DSM/SCM. Apply the T6031G07^ACH SPR of DSM/SCM before receiving the G06.32
SUT.
After you activate the T6031G07^ACH server software, the ZDSMEXE file will be
available to download from the ZDSMSCM subvolume so that you can update the
client. (You do not need to update the DSM/SCM client to the T6031G02 server side
immediately to receive the G06.32 RVU successfully.) However, HP recommends that,
for your production environment, both the client and server side of DSM/SCM PVUs
match.
Appendix C, Installing the Latest DSM/SCM SPRs and Client Software
contains
instructions for installing a G02 PVU of DSM/SCM, including the client.
Caution. You must install at least a D46 client version of DSM/SCM to activate DSM/SCM
management of OSS files for a target. HP recommends that you install T6031G02.