GDSX Manual

DEVICE^HANDLER Example, Running and
Managing
Extended General Device Support (GDSX) Manual–134303
4-13
Stopping the First Application and GDSX
At the first application terminal, after the CPU number and PIN prompt, you should see
the message:
D^H TASK STOPPED
At a TACL prompt, enter:
> STATUS *, TERM
Requester process $A1 should not appear.
If you enter the following command at the SCF prompt:
-> INFO SU
you should see a message that the object does not exist.
Then enter:
-> STOP PROCESS $GDS!
-> EXIT
The GDSX process is stopped and you exit from SCF. You may need to use the Break
key to get a TACL prompt.
Confirm that the GDSX process is gone by entering:
> STATUS *, TERM
Clear the values set by the PARAMs commands:
> CLEAR ALL