GDSX Manual

Using Pseudo Procedures in a NonStop TS/MP
Environment
Extended General Device Support (GDSX) Manual–134303
D-21
Starting NonStop TS/MP
SET PATHWAY MAXLINKMONS 1
SET PATHWAY MAXEXTERNALTCPS 1
SET PATHWAY MAXSERVERCLASSES 2
SET PATHWAY MAXSERVERPROCESSES 4
SET PATHWAY MAXSTARTUPS 10
SET PATHWAY MAXPATHCOMS 3
SET PATHWAY MAXASSIGNS 5
SET PATHWAY MAXPARAMS 5
START PATHWAY COLD !
LOG1 PATHLOG, STATUS
RESET SERVER
SET SERVER
SET SERVER PROGRAM DELETERO
SET SERVER PROCESS $GDS1
SET SERVER PROCESS $GDS2
SET SERVER CPUS (1:0, 0:1)
SET SERVER MAXSERVERS 2
SET SERVER CREATEDELAY 1 SECS
SET SERVER DELETEDELAY 30 MINS
SET SERVER NUMSTATIC 1
SET SERVER SECURITY "N"
SET SERVER TMF ON
SET SERVER (ASSIGN TSTDAT, $SKY.LINZ,TSTDAT, SHARED)
ADD SERVER DELETER
RESET SERVER
SET SERVER
SET SERVER PROGRAM WRITERO
SET SERVER PROCESS $GDS3
SET SERVER PROCESS $GDS4
SET SERVER CPUS (0:1, 1:0)
SET SERVER MAXSERVERS 2
SET SERVER CREATEDELAY 1 SECS
SET SERVER DELETEDELAY 20 MINS
SET SERVER NUMSTATIC 1
SET SERVER SECURITY "N"
SET SERVER TMF ON
SET SERVER (ASSIGN TSTDAT, $SKY.LINZ.TSTDAT, SHARED)
ADD SERVER WRITER
At the TACL prompt the following commands are entered to start the NonStop TS/MP
application:
> FUP PURGEDATA PATHLOG
> ASSIGN PATHCTL, \SKY.LINZ.PATHCTL
> PATHMON /NAME $PWGDS, NOWAIT, PRI 150, MEM 64, CPU 0/
> PATHCOM /IN PATHIN/ $PWGDS
At this point the NonStop TS/MP application named $PWGDS is configured and
started, but the GDSX application is not running.