Gigabit Ethernet 4-Port Adapter Installation and Support Guide

Gigabit Ethernet 4-Port ServerNet Adapter Installation and Support Guide—528166-006
2-1
2 Installing a G4SA
This section describes how to configure and install a Gigabit Ethernet 4-port ServerNet
adapter (G4SA) in an I/O adapter module (IOAM) enclosure. A G4SA can be installed
without shutting down the system.
This section includes the following topics:
Prepare to Install a G4SA
Plan the Local Area Network (LAN)
For information about planning your LAN and about network addresses, review the
LAN Configuration and Management Manual, and refer, if necessary, to the following
manuals:
•
TCP/IP (Parallel Library) Configuration and Management Manual
•
TCP/IP Configuration and Management Manual
•
TCP/IPv6 Configuration and Management Manual
•
IPX/SPX Configuration and Management Manual
•
PAM Configuration and Management Manual
Prepare to Install a G4SA Page 2-1
Install a G4SA Page 2-5
Table 2-1. Preparation Checklist
Step Description
1. Plan the Local Area Network (LAN)
2. Complete the Planning and Configuration Forms
3. Gather the Proper Tools
4. Review Standard Operating Practices
Note. IPS/SPX is not supported on systems running H-series or J-series RVUs.
Note. There are different considerations for LAN planning on BladeSystems which run on
J-series RVUs. Refer to the Integrity NonStop BladeSystem Planning Guide for further
information.