Gigabit Ethernet 4-Port Adapter Installation and Support Guide

Replacing a G4SA
Gigabit Ethernet 4-Port ServerNet Adapter Installation and Support Guide—528166-006
3-3
Identify Any Communications Lines and ServerNet
Wide Area Network (SWAN) Using the G4SA
When SUBNETs are configured for use with the NonStop TCP/IPv6 product, the
INFO SUBNET display differs from the one shown above. For NonStop TCP/IPv6,
the display consists of an AF_INET section that lists IPv4 SUBNET addresses and
an AF_INET6 section that lists IPv6 SUBNET addresses. If any SUBNETS have
been configured with IPv6 addresses, the LinkLevelAddress field under AF_INET6
shows them:
3. Use the SCF NAMES command to identify the Port Access Method (PAM) lines
configured on the system.
NAMES $ZZPAM
In Example 3-4 on page 3-4, which is a partial output, one PAM line named $TOK1
is configured.
Example 3-2. SCF INFO SUBNET Command
->INFO SUBNET $*.*
TCPIP Info SUBNET \DRAGON.$ZB1EJ.*
Name Devicename *IPADDRESS TYPE *SUBNETMASK SuName QIO *R
#LOOP0 \SYS123.$NOIOP 127.0.0.1 LOOP-BACK %HFF000000 OFF N
#SN1 \MYSYS.L112J 172.16.40.64 ETHERNET %HFFFFFF00 ON N
#SN2 \MYSYS.L01C 172.16.35.15 SNAP %HFFFFFF00 ON N
Example 3-3. SCF INFO SUBNET Command (NonStop TCP/IPv6)
INFO SUBNET $*.*
TCPIPV6 Info SUBNET \MYSYS.$ZZTCP.*
AF_INET:
Name Devicename *IPADDRESS TYPE *SUBNETMASK *R
SN2 \MYSYS.LAN14 172.16.214.28 ETHERNET %HFFFFFF00 N
SN1 \MYSYS.LAN12 172.16.214.27 ETHERNET %HFFFFFF00 N
LOOP0 127.0.0.1 LOOP %HFF000000 N
AF_INET6:
Name Devicename LinkLevelAddress TYPE
SN2 \MYSYS.LAN14 fe80::a00:8eff:fe04:6eee ETHERNET
SN1 \MYSYS.LAN12 fe80::a00:8eff:fe04:6ef2 ETHERNET
LOOP0 ::1 LOOP
TUN ::172.16.214.27 A-TUNNEL