Gigabit Ethernet 4-Port Adapter Installation and Support Guide

Replacing a G4SA
Gigabit Ethernet 4-Port ServerNet Adapter Installation and Support Guide—528166-006
3-6
Identify Any Communications Lines and ServerNet
Wide Area Network (SWAN) Using the G4SA
8. Use the SCF INFO LINE command with the DETAIL option for each Expand-over-
IP line you identified in Step 7 to determine if any of the Expand-over-IP lines
configured on the system use the ports on the G4SA to be replaced. Write down
the Expand-over-IP line that uses the TCP/IP processes and IP addresses on your
worksheet.
INFO LINE $line-name, DETAIL
In Example 3-9, the Expand-over-IP line uses the TCP/IP process named $ZTC23
and the IP address 172.17.203.37.
9. Use the SCF NAMES ADAPTER command to identify the names of the SWAN
concentrators configured on the system (see Example 3-10).
NAMES ADAPTER $ZZWAN.#*
Example 3-8. SCF LISTDEV Command
->LISTDEV TYPE 63,0
LDev Name PPID BPID Type Rsize Pri Program
109 $IPYEA 3,9 2,7 (63,0) 3 199 \MYSYS.$DATA00.T9057ADJ.LHOBJ
159 $IPCORE 0,16 1,15 (63,0) 3 199 \MYSYS.$DATA00.T9057ADJ.LHOBJ
In this example, two Expand-over-IP lines (named $IPYEA and $IPCORE) are
configured on the system.
This is an example of the SCF LISTDEV command display for Expand-over-IP lines
that are part of a multiline path:
->LISTDEV TYPE 63,2
LDev Name PPID BPID Type Rsize Pri Program
56 $IPC03 2,16 3,16 (63,2) 3 199 \MYSYS.$DATA00.T9057ADJ.LHOBJ
84 $IPC02 2,16 3,16 (63,2) 3 199 \MYSYS.$DATA00.T9057ADJ.LHOBJ
Example 3-9. SCF INFO LINE Command
->INFO LINE $IPYEA,DETAIL
EXPAND Detailed Info LINE $IPYEA
*Associatedev... $ZTC23 *Maxconnects. 0 Delay.... 0:00:00.10
Framesize...... 132 *Speed....... 74666 *Retryprobe 3
*Timerinactivity 0:00:00.00 *Timerprobe.. 0:00:30.00 Txwindow.. 7
*AfterMaxRetries PASSIVE StartUp...... OFF Rsize..... 3
*Timerreconnect. 0:00:30.00 L2Protocol... Net^IP
*DestIpAddr 172.17.203.37 *DestIpPort 2003
*SrcIpAddr 172.17.208.20 *SrcIpPort 2003
Note. If NonStop TCP/IPv6 is the implementation of TCP/IP, the DestIpAddr and
SrcIpAddr fields in the INFO LINE, DETAIL display might contain IPv6 addresses.