Gigabit Ethernet 4-Port Adapter Installation and Support Guide

Replacing a G4SA
Gigabit Ethernet 4-Port ServerNet Adapter Installation and Support Guide—528166-006
3-12
To Stop a Port Access Method (PAM) Line
2. Use the SCF STATUS LINE command to verify that the PAM line is in the
STOPPED state (Example 3-21).
STATUS LINE $line-name
To Stop a TCP/IP SUBNET
1. Use the SCF STOP SUBNET command to stop the TCP/IP SUBNET.
STOP SUBNET $tcpip-process-name.#subnet-name
2. Use the SCF STATUS SUBNET command to verify that the TCP/IP SUBNET is in
the STOPPED state (see Example 3-22).
STATUS SUBNET $tcpip-process-name.#subnet-name
Example 3-21. SCF STATUS LINE Command
->STATUS LINE $TOK1
PAM Status LINE
Primary Backup
Name State CPU PIN CPU PIN Trace
$TOK1 STOPPED 1 278 -1 -1 OFF
Caution. Make sure that the TACL session from which you are issuing SCF commands is not
running on the SUBNET that you are about to stop.
Note. To stop a TCP/IP SUBNET that is configured using Parallel Library TCP/IP, refer to the
TCP/IP (Parallel Library) Configuration and Management Manual. To stop a TCP/IP SUBNET
that is configured using NonStop TCP/IPv6, refer to the TCP/IPv6 Configuration and
Management Manual.
Example 3-22. SCF STOP SUBNET Command
->STATUS SUBNET $ZTC01.#SN2
TCPIP Status SUBNET \COWBOY.$ZTC01.#SN2
Name Status
#SN2 STOPPED