Gigabit Ethernet 4-Port Adapter Installation and Support Guide

Replacing a G4SA
Gigabit Ethernet 4-Port ServerNet Adapter Installation and Support Guide—528166-006
3-15
Label the Communication Cables Connected to the
G4SA
Label the Communication Cables Connected to the G4SA
1. Find the group, module, and slot of the IOAM in which the Gigabit Ethernet 4-port
ServerNet adapter (G4SA) is installed.
2. Tag the communication cables connected to the G4SA with physical labels,
preferably at both cable ends. The label should include the:
•
Physical interface (PIF) name assigned to the line (for example, G1123.0.A)
•
Description of the equipment and connector to which the cables are to be
connected
•
Rack name, rack offset, and locator text of the IOAM enclosure in which the
G4SA is installed.
•
Slot location of the G4SA to which the cable is connected
Replace the G4SA
Review Standard Operating Practices
See Review Standard Operating Practices on page 2-3.
Remove the Adapter
1. Place an antistatic table mat and an ESD protective bag for the adapter to be
removed on a flat horizontal work surface near the IOAM enclosure.
Example 3-25. SCF STATUS ADAPTER Command
->STATUS ADAPTER $ZZLAN.G1123
SLSA Status ADAPTER
Name State
$ZZLAN.G1123 STOPPED
Table 3-2. Replacement Checklist
Step Description
1.
Review Standard Operating Practices
2.
Remove the Adapter
3.
Unpack and Inspect the G4SA
4.
Install the G4SA
5.
Verify the Installation of the G4SA
Note. Whenever you handle a G4SA, follow standard operating practices to avoid damage to
the equipment.