Gigabit Ethernet 4-Port Adapter Installation and Support Guide

Replacing a G4SA
Gigabit Ethernet 4-Port ServerNet Adapter Installation and Support Guide—528166-006
3-16
Remove the Adapter
2. Disconnect the communication cables from the G4SA.
3. Put on your electrostatic discharge (ESD) wrist strap and connect the grounding
clip securely to either an unpainted metal surface on the IOAM enclosure or on the
rack in which the enclosure is installed (see Figure 2-1 on page 2-4).
4. Press down on the purple ejector latch and pull the G4SA’s handle outward to unseat the
adapter.
Note. The G4SA weighs approximately 7 pounds (3 kilograms).
VST045.vsd