Gigabit Ethernet 4-Port Adapter Installation and Support Guide

Replacing a G4SA
Gigabit Ethernet 4-Port ServerNet Adapter Installation and Support Guide—528166-006
3-19
Start the G4SA
Using SCF to Verify that Objects Are in the STARTED State
1. Use the SCF STATUS ADAPTER command to verify the adapter is in the
STARTED state (see Example 3-26).
STATUS ADAPTER $ZZLAN.adapter-name.*
2. Use the SCF STATUS SAC command to verify that the ServerNet addressable
controller (SAC) is in the STARTED state (see Example 3-27).
STATUS SAC $ZZLAN.adapter-name.*
3. Use the SCF STATUS PIF command to verify that the physical interfaces (PIFs)
are in the STARTED state (see Example 3-28).
STATUS PIF $ZZLAN.adapter-name.*
Example 3-26. SCF STATUS ADAPTER command
->STATUS ADAPTER $ZZLAN.G1123
SLSA Status ADAPTER
Name State
$ZZLAN.G1123 STARTED
Example 3-27. SCF STATUS SAC command
->STATUS SAC $ZZLAN.G1123.*
SLSA Status SAC
Name Owner State Trace Status
$ZZLAN.G1123.0 1 STARTING OFF
Example 3-28. SCF STATUS PIF command
->STATUS PIF $ZZLAN.G1123.*
SLSA Status PIF
Name State Trace Status
$ZZLAN.G1123.0.A STARTING OFF
$ZZLAN.G1123.0.B STARTING OFF
$ZZLAN.G1123.0.C STARTING OFF
$ZZLAN.G1123.0.D STARTING OFF