Gigabit Ethernet 4-Port Adapter Installation and Support Guide

Relocating a G4SA

Gigabit Ethernet 4-Port ServerNet Adapter Installation and Support Guide—528166-006

4-4

Locate the New Slot

Find the IOAM group, module, and slot containing the G4SA to be relocated and the

empty slot where you will relocate the adapter. This empty slot should contain a filler

panel. If it does not, you will need a filler panel for the slot left vacant by the G4SA you

move.

Label the Communication Cables Connected to the G4SA

Follow the procedure described in Label the Communication Cables Connected to the

G4SA on page 3-15 to label the communication cable.

Remove and Relocate the G4SA

Review Standard Operating Practices

See Review Standard Operating Practices on page 2-3 and Figure 2-1 on page 2-4.

Remove the Adapter

Follow the procedure described in Remove the Adapter on page 3-15.

Move the G4SA and Install It in Its New Slot

Follow the procedure described in Install the G4SA on page 2-6.

Verify the Installation of the G4SA

Follow the procedure on Verify the Installation of the G4SA on page 2-9.

Resume Operations

Table 4-3 describes starting the relocated G4SA.

Table 4-2. Replacement Checklist

Step Description

Review Standard Operating Practices

Remove the Adapter

Move the G4SA and Install It in Its New Slot

Verify the Installation of the G4SA

Note. Whenever you handle a G4SA, follow standard operating practices to avoid damage to

the equipment.

Note. Make sure that you reinstall a filler panel in the empty adapter slot.