Gigabit Ethernet ServerNet Adapter Installation and Support Guide

Introduction to the Gigabit Ethernet ServerNet
Adapter (GESA)
Gigabit Ethernet Adapter Installation and Support Guide—523628.005
1-3
GESA-C External Connectors, Indicators, and
Cables
•
Supported by OSM and TSM client software to facilitate diagnostics and
maintenance.
•
Supports bandwidth-intensive applications.
GESA-C External Connectors, Indicators, and Cables
The GESA-C external connector consist of one 10/100/1000 Base-T RJ-45 type
connector.
The GESA-C external light-emitting diode (LED) indicators consist of:
•
Two status LEDs for the GESA-C
•
Four status LEDs for the Gigabit Ethernet port
Figure 1-1 on page 1-4 shows the position of these external connectors and indicators.
The GESA-C status LEDs are controlled by the Service Processor (SP) and indicate
the state of the adapter:
The Gigabit Ethernet port status LEDs indicate the activity on and state of the Gigabit
Ethernet port:
LED GESA-C State
Green Power-on
Amber Fault condition
LED Port State Description
1000 On
Off
Gigabit Ethernet link is connected
Gigabit Ethernet link is not connected
100 On
Off
Fast Ethernet (100 Mbps) is connected
Fast Ethernet link is not connected
10 On
Off
Ethernet (10 Mbps) is connected
Ethernet link is not connected
ACT Blinking
On
Off
Burst of data detected on the port
Data is streaming on the port
No data is detected on the port