Gigabit Ethernet ServerNet Adapter Installation and Support Guide

Replacing a GESA
Gigabit Ethernet Adapter Installation and Support Guide—523628.005
3-5
Identify Any Communications Lines and ServerNet
Wide Area Network (SWAN) Using the GESA
2. Use the SCF INFO SUBNET command to determine the TCP/IP process, subnet,
and Internet Protocol (IP) address associated with the LIF on the GESA to be
replaced (see Example 3-2). Write down the associated LIF, TCP/IP process,
subnet, and IP address on your worksheet.
INFO SUBNET $*.*
When subnets are configured for use with the NonStop TCP/IPv6 product, the
INFO SUBNET display differs from the one shown above. For NonStop TCP/IPv6,
the display consists of an AF_INET section that lists IPv4 subnet addresses and an
AF_INET6 section that lists IPv6 subnet addresses. If any subnets have been
configured with IPv6 addresses, the LinkLevelAddress field under AF_INET6
shows them:
3. Use the SCF NAMES command to identify the PAM lines configured on the system
(see Example 3-4).
NAMES $ZZPAM
Example 3-2. SCF INFO SUBNET Command
->INFO SUBNET $*.*
TCPIP Info SUBNET \DRAGON.$ZB018.*
Name Devicename *IPADDRESS TYPE *SUBNETMASK SuName QIO *R
#LOOP0 \NOSYS.$NOIOP 127.0.0.1 LOOP-BACK %HFF000000 OFF N
#SN1 \DRAGON.L018 172.16.40.64 ETHERNET %HFFFFFF00 ON N
#SN2 \DRAGON.L01C 172.16.35.15 SNAP %HFFFFFF00 ON N
Example 3-3. SCF INFO SUBNET Command (NonStop TCP/IPv6)
INFO SUBNET $*.*
CPIPV6 Info SUBNET \BEAR.$ZZTCP.*
AF_INET:
Name Devicename *IPADDRESS TYPE *SUBNETMASK *R
SN2 \BEAR.LAN14 172.16.214.28 ETHERNET %HFFFFFF00 N
SN1 \BEAR.LAN12 172.16.214.27 ETHERNET %HFFFFFF00 N
LOOP0 127.0.0.1 LOOP %HFF000000 N
AF_INET6:
Name Devicename LinkLevelAddress TYPE
SN2 \BEAR.LAN14 fe80::a00:8eff:fe04:6eee ETHERNET
SN1 \BEAR.LAN12 fe80::a00:8eff:fe04:6ef2 ETHERNET
LOOP0 ::1 LOOP
TUN ::172.16.214.27 A-TUNNEL