Gigabit Ethernet ServerNet Adapter Installation and Support Guide

Replacing a GESA
Gigabit Ethernet Adapter Installation and Support Guide—523628.005
3-11
Stop the Communications Lines and SWAN
Concentrator Line Using the GESA
To Stop an Expand-over-IP Line:
1. Abort the Expand-over-IP line.
•
To stop a single line, use the SCF ABORT LINE command:
ABORT LINE $line-name
•
To stop all the lines in an Expand multiline path, use the SCF ABORT PATH
command:
ABORT PATH $path-name
2. Verify that the Expand-over-IP line is in the STOPPED state.
•
To verify a single line is stopped, use the SCF STATUS LINE command (see
Example 3-17):
STATUS LINE $line-name
•
To verify a multiline path is stopped, use the SCF STATUS PATH command for
an Expand multiline path (see Example 3-18):
STATUS PATH $path-name
Example 3-16. SCF STATUS ADAPTER Command
->STATUS ADAPTER $ZZWAN.#S01
WAN Manager STATUS ADAPTER for ADAPTER \COWB0Y.$ZZWAN.#S01
State....... STOPPED
Number of clips. 3
Clip 1 status : CONFIGURED
Clip 2 status : CONFIGURED
Clip 3 status : CONFIGURED
Example 3-17. SCF STATUS LINE Command
->STATUS LINE $LINE1
EXPAND Status LINE
Name State PPID BPID CIU-Path ConMgr-LDEV
$LINE1 STOPPED 2, 10 3, 7 A 91
Example 3-18. SCF STATUS PATH Command
->STATUS PATH $PATH
EXPAND Status PATH
Name State PPID BPID Lines #
$PATH STOPPED 2, 15 3, 15 2