Gigabit Ethernet ServerNet Adapter Installation and Support Guide

Replacing a GESA
Gigabit Ethernet Adapter Installation and Support Guide—523628.005
3-12
Stop the Communications Lines and SWAN
Concentrator Line Using the GESA
3. Use the SCF STOP DEVICE command to stop the WAN subsystem IOPs.
STOP DEVICE $ZZWAN.#device-name
4. Use the SCF STATUS DEVICE command to verify that the WAN subsystem IOPs
are in the STOPPED state (see Example 3-19).
STATUS DEVICE $ZZWAN.#device-name
To Stop an IPXPROTO Process
1. Stop the IPXPROTO process.
•
For a IPXPROTO process configured as a generic process, use the Kernel
subsystem SCF ABORT PROCESS command:
ABORT PROCESS $ZZKRN.#gpname
•
For a IPXPROTO process not configured as a generic process, use the SLSA
subsystem SCF STOP PROCESS command:
STOP PROCESS $process-name
2. Use the SCF STATUS PROCESS command to verify that the IPXPROTO process
is in the STOPPED state see (Example 3-20).
STATUS PROCESS $process-name
Example 3-19. SCF STATUS DEVICE Command
->STATUS DEVICE $ZZWAN.#LINE1
WAN Manager STATUS DEVICE for DEVICE \COWBOY.$ZZWAN.#LINE1
State :........ STOPPED
LDEV number.... 110
PPIN........... 2 ,13 BPIN......... 3 ,14
Example 3-20. SCF STATUS PROCESS Command
->STATUS PROCESS $ZNV2
IPXSPX Status PROCESS
Process Name State Diagnostic State Trace
$ZNV2 STOPPED NORMAL OFF