Gigabit Ethernet ServerNet Adapter Installation and Support Guide

Replacing a GESA
Gigabit Ethernet Adapter Installation and Support Guide—523628.005
3-16
Replace the GESA
Replace the GESA
Review Standard Operating Practices
See Review Standard Operating Practices on page 2-6.
Remove the Adapter
1. Disconnect the communication cable from the GESA.
2. Put on your electrostatic discharge (ESD) wrist strap and connect the grounding
clip securely to an unpainted metal surface on the service side of the system
enclosure, such as the processor multifunction (PMF) CRU or I/O multifunction
(IOMF) CRU ventilation holes (see Figure 2-4 on page 2-9).
Table 3-2. Replacement Checklist
Step Description
1.
Review Standard Operating Practices.
2.
Remove the Adapter.
3.
Unpack and Inspect the GESA.
4.
Install the GESA
5.
Verify the Installation of the GESA.
Note. Whenever you handle a GESA, follow standard operating practices to avoid damage to
the equipment.