Gigabit Ethernet ServerNet Adapter Installation and Support Guide

Replacing a GESA
Gigabit Ethernet Adapter Installation and Support Guide—523628.005
3-23
Verify that the Communications Lines are Restarted
2. Use the SCF STATUS PROCESS command to verify that the IPXPROTO process
is started (see Example 3-31).
STATUS PROCESS $line-name
3. Use the SCF STATUS LINE command to verify that a Port Access Method (PAM)
line is started (see Example 3-32).
STATUS LINE $line-name
4. Verify that an Expand-over-IP line is started:
a. Use the SCF STATUS DEVICE command to verify that the WAN subsystem
IOP is in the STARTED state:
STATUS DEVICE $ZZWAN.#device-name
b. Use the SCF STATUS LINE command for a single line to verify that the line is
in the STARTED state.
STATUS LINE $line-name
5. Use the SCF STATUS PATH command to verify that the Expand multiline path is
started (see Example 3-33
).
STATUS PATH $path-name
Example 3-31. SCF STATUS PROCESS Command
->STATUS PROCESS $ZNV2
IPXSPX Status PROCESS
Process Name State Diagnostic State Trace
$ZNV2 STARTED NORMAL OFF
Example 3-32. SCF STATUS LINE Command
->STATUS LINE $TOK1
Primary Backup
Name State CPU PIN CPU PIN Trace
$TOK1 STARTED 1 278 -1 -1 OFF
Example 3-33. SCF STATUS PATH Command
->STATUS PATH $PATH
EXPAND Status PATH
Name State PPID BPID Lines #
$PSHOT STARTED 2, 15 3, 15 2