Gigabit Ethernet ServerNet Adapter Installation and Support Guide

Relocating a GESA
Gigabit Ethernet Adapter Installation and Support Guide—523628.005
4-3
Stop the Communications Lines and SWAN
Concentrator Line Using the GESA
Stop the Communications Lines and SWAN Concentrator Line
Using the GESA
Follow the procedure described in Stop the Communications Lines and SWAN
Concentrator Line Using the GESA on page 3-9.
Determine the Physical Location of the GESA
Follow the procedure described in Determine the Physical Location of the GESA on
page 3-14:
Stop the GESA
1. Use the SCF INFO LIF command to determine the name of the logical interface
(LIF) associated with the GESA to be relocated (see Example 4-1):
INFO LIF $ZZLAN.*
2. Use the SCF STOP LIF command for each LIF to stop access to the logical
interface (LIF) associated with the GESA to be relocated.
STOP LIF $ZZLAN.lif-name
If you receive a message that the LIF client is still active, use the SCF ABORT LIF
command to remove the LIF.
3. Use the SCF STATUS LIF command to verify that the LIF associated with the
GESA to be relocated is in the STOPPED state (see Example 4-2):
STATUS LIF $ZZLAN.*
Example 4-1. SCF INFO LIF Command
->INFO LIF $ZZLAN.*
SLSA Info LIF
Name PIF MAC Address Type
$ZZLAN.L018 E0153.0.A 08:00:8E:00:5C:85 Ethernet
Example 4-2. SCF STATUS LIF Command
->STATUS LIF $ZZLAN.*
SLSA Status LIF
Name State Access State
$ZZLAN.L018 STOPPED UP