Gigabit Ethernet ServerNet Adapter Installation and Support Guide

Relocating a GESA
Gigabit Ethernet Adapter Installation and Support Guide—523628.005
4-5
Remove and Relocate the GESA
Remove and Relocate the GESA
Review Standard Operating Practices
See Review Standard Operating Practices on page 2-6 and Figure 2-3 on page 2-7.
Remove the Adapter
Follow the procedure described in Remove the Adapter on page 3-16.
Move the GESA and Install It in Its New Slot
Follow the procedure described in Install the GESA on page 2-9.
Verify the Installation of the GESA
Follow the procedure on Verify the Installation of the GESA on page 2-15.
Resume Operations
Table 4-3 describes starting the relocated GESA.
Table 4-2. Replacement Checklist
Step Description
1.
Review Standard Operating Practices.
2.
Remove the Adapter.
3.
Move the GESA and Install It in Its New Slot.
4.
Verify the Installation of the GESA.
Note. Whenever you handle a GESA, follow standard operating practices to avoid damage to
the equipment.
Note. Make sure that you reinstall a filler panel in the empty adapter slot.
Table 4-3. Resuming Operations Checklist
Step Description
1.
Complete the Configuration Form.
2.
Add and Start the GESA Using SCF.