Guardian Disk and Tape Utilities Reference

7270
Volume mode backup and restore can only be performed under
the SUPER.SUPER user ID.
Cause. An attempt was made to perform a volume-mode BACKUP or RESTORE with a user ID other
than the super ID (255,255).
Effect. BACKUP or RESTORE terminates.
Recovery. Log on as the super ID and retry the operation.
7271
The audit record cannot be sent to the Audit Collector due to
file-system-name.
Cause. A file-system error occurred during the attempt to send an audit record to the Safeguard
product during a volume-mode backup.
Effect. BACKUP continues.
Recovery. For more information, see the Guardian Procedure Errors and Messages Manual.
7274
Trust flag turned off.
Cause. The state of FLTrustFlags for the file being restored is set to OFF.
Effect. None.
Recovery. Informational message only; no corrective action is needed.
NOTE: Message 7274 appears only on systems running H-series RVUs or J-series RVUs.
7500
Not positioned to the beginning of the tape.
Cause. An attempt was made to run BACKUP or RESTORE before positioning the tape to the
beginning of the tape.
Effect. BACKUP or RESTORE terminates.
Recovery. Reenter the command after positioning the tape to the beginning.
7501
7 track tape drive cannot be used for BACKUP/RESTORE. Must
be a 9 track drive.
Cause. An attempt was made to run BACKUP or RESTORE with a 7-track tape drive.
Effect. BACKUP or RESTORE terminates.
Recovery. Use a 9-track tape drive.
208 BACKCOPY, BACKUP, and RESTORE Messages